Skip to main content

Favorite Links into the Forum and the Wiki

Here is my collection of Links into the Forum and into the Wiki for easier access.

Wiki



Forum


Why the P2S only provides 2 options when it comes to selecting the filament in the printers menu:

Answer from Support via Email

[English translated by Copilot]
Dear Customer,

Thank you very much for your feedback. Regarding your question about why you cannot select filament from alternative manufacturers on the P2S, we would like to explain the reasons and offer a solution.

Filament parameters depend heavily on the properties of the respective printer. Based on our tests and evaluations, filament parameters from older models cannot usually be directly applied to newer models. Therefore, for new models like the P2S, we are following a new strategy: We do not provide preset profiles for third-party filaments, but instead encourage external filament manufacturers or developers to submit parameters for the new models. We will review and validate these parameters, and once confirmed, they will be added in future software updates.

Therefore, the P2S currently only supports Bambu Lab’s own filament and the “Generic Filament” type. Whether and when profiles for filaments such as Sunlu, eSun, etc., will be added depends on if and when third-party providers or developers submit suitable parameters.

Your custom filament profiles created in Bambu Slicer for the A1 cannot currently be transferred directly to the P2S due to differences between the models. As a temporary solution, we recommend:

  1. Select the “Generic Filament” type on the P2S and manually adjust parameters such as temperature and flow rate.
  2. Please keep an eye on future software updates from Bambu Lab, as we will gradually expand support for additional third-party filaments.

Thank you again for your understanding and support! If you have any further questions, please feel free to contact us at any time.

Best regards,
Bambu Lab Customer Support
[/English translated by Copilot]

https://forum.bambulab.com/t/p2s-has-only-2-filament-options/204928/6


Print Cancelled, but why and by what?

This topic is about why prints canceled despite having enough filament, no model crash, no head crash, no spaghetti or whatsoever. It basically comes down to a BAD SD CARD on the P1S or bad medium to store log, files, Timelapse's etc.

Since I did not have any issues after I changed the stock SD Card, I think this is gone. But could also be eliminated via a firmware update. Did not checked on that one.

https://forum.bambulab.com/t/print-cancelled-but-why-and-by-what/118998


No comments to display

Back to top